Filter
Top Products
15
For legacy devices that are not yet compatible, the PoE port will
not offer the power to these devices. This feature allows users to
freely and safely mix legacy and Power over Ethernet compatible
devices on their network.
These ports support network speeds of either 10Mbps or
100Mbps, and can operate in half- and full-duplex transfer modes.
These ports also support the automatic MDI/MDIX crossover
detection function, providing true “plug and play” capability. Just
plug-in the network cable to the Switch directly and regardless if
the end node is a NIC (Network Interface Card) or switch and
Switch.
1000BASE-T Gigabit Ethernet Ports (Port 25~26):
The Switch is equipped with two Gigabit twisted pair ports,
supported auto negotiable 10/100/1000Mbps and auto
MDI/MDIX crossover detection function. These two ports can
operate in half-duplex mode for 10/100Mbps and full-duplex mode
for 10/100/1000Mbps.
Note: When the port is set to “Forced Mode”, the Auto MDI/MDIX
will be disabled.
mini-GBIC Ports (Port 25F~26F):
The Switch is equipped with two mini-GBIC ports, which
supports optional 1000BASE-SX/LX mini-GBIC modules.
Note: Port 25 and 26 are the same ports with the mini-GBIC Port
25F and 26F ports, when plug in the mini-GBIC module, the device
will activate mini-GBIC, and the RJ-45 port will be disabled.