Filter
Top Products
18
3. REPLACING A HALOGEN LAMP
TROUBLESHOOTING
The Refrigerator Does Not Cool Properly
A. Burner jet clogged.
Clean. (See section Maintenance & Service, Item 2.
Periodic Maintenance, Paragraph D. Item 1-13.)
B. Check level of refrigerator.
C. Venting problem.
Restriction in air flow across cooling unit.
D. Flue baffle not inserted properly in flue tube.
E. Improperly set thermostat.
(See section Operating Instructions, part Start Up
Instructions. “Set thermostat range”).
F. Burner dirty.
Clean. (See section Maintenance & Service, Item 2.
Periodic Maintenance, Paragraph D. Item 1-13.)
G. LP gas pressure low at burner.
Set main regulator so pressure does not drop
below 11 inches water column at pressure tap.
H. Burner not located properly under flue tube.
Relocate.
I. Burner damaged.
Replace.
J. Odors from fumes.
1. Dislocated burner.
2. Damaged burner.
3. Dirty flue tube.
K. FUSES
See wiring diagram
If the refrigerator fails to work, check the following
points before calling a service technician:
• that the fuses are intact
• that the power cord is plugged in
• that 12 volt DC is connected to the refrigerator
The refrigerator is equipped with an overheating protec-
tion.
An authorized service technician can check if it has been
triggered or not.
NOTE: AVOID SPRAYING WATER THROUGH THE
REFRIGERATOR VENTS WHILE WASHING YOUR RV.
All the above instructions are to be followed closely. The
refrigerator is quality-guaranteed. However, we are not
responsible for any failures caused by improper adjust-
ments and unfavorable installation conditions. Contact
service point or distributor service dept. for assistance.
Turn off the refrigerator before replacing the lamp.
Wear gloves as protection against hot lamp, broken
glass and as protection of the new lamp.
Refrigerator
The lamp is located at the top of the refrigerator com-
partment.
To replace the lamp proceed as follows:
• unhook the tab on the lamp cover by pressing in
with the thumb on the side of the lamp cover.
• remove the lamp cover.
• with gloves, pull out the lamp from the socket and
replace it with a new 12V, 10-watt (maximum)
halogen lamp base G4.
• replace the lamp cover by placing the two tabs into
the corresponding slots of the lamp house and
press the tab into place.
Freezer
The lamp is located on the right side of the freezer com-
partment.
To replace the lamp proceed as follows:
• unhook the tab on the lamp cover by pressing in
with the thumb on the side of the lamp cover.
• remove the lamp cover.
• with gloves, pull out the lamp from the socket and
replace it with a new 12V, 5-watt (maximum)
halogen lamp base G4.
• replace the lamp cover by placing the two tabs into
the corresponding slots of the lamp house and
press the tab into place.
! CAUTION