Filter
Top Products
8
CERTIFIED INSTALLATION
Certified installations require one roof vent and one lower
side vent.
For “Certified Vent System Kits” see page 19.
For further information contact your dealer or distributor.
METHODS OF INSTALLATION
The method of installation is shown in FIG. 9. It is essen-
tial that all maximum or minimum dimensions are strictly
maintained as the performance of the refrigerator is de-
pendent on adequate flow of air over the rear of the re-
frigerator.
NOTE: The upper vent should be centered over the
condenser coil at the back of the refrigerator.
VENTILATION HEIGHTS
CLEARANCES
Minimum clearances in inches to combustible materials
are:
G: Top 0
K: Side 0
L: Bottom 0
M: Rear 0
N: See NOTE: Clearance “N” below.
NOTE: Clearance “M” is between the rearmost part of
the refrigerator and the wall behind the refrigerator.
NOTE: Clearance “N” is the distance between the bot-
tom of the lower vent to the roof material. For ventilation
height, see table VENTILATION HEIGHTS
See Figures 9, and 10.
LOWER VENT CUTOUT
13-5/8”
28-5/8”
FIG. 9
Ventilation
height
Condenser
FIG. 10
Installation with roof Minimum ventilation
vent and lower side vent heights in:
Refrigerator Inches mm
NDA 1402 69-1/8 1756
K
L
NOTE: Wood Strip
MUST be in place
G
K
N
M