Filter
Top Products
7
Step 2: Two screws installed in the top frame.
Open the doors and fasten the refrigerator with two
screws through the holes underneath the top decoration
panel. See FIG. 7.
TESTING LP GAS SAFETY
SHUT OFF
The gas safety shut off must be tested after the re-
frigerator is connected to LP gas supply.
To test the gas safety shut off, proceed as follows:
1. Start the refrigerator according to the instructions,
and switch to GAS mode. (See start up instructions
“Select energy mode of operation”).
2. Check that the dot for GAS mode on the LED is on,
check that the gas flame is lit.
3. Close the manual gas shut off valve at the back of
the refrigerator. (See FIG. 1).
4. Wait until “ch LP” is flashing on the LED panel
approximately 6 to 7 minutes.
5. Remove protection cover (see FIG. 1) and open the
manual gas shut off valve. Do not change any
button positions on the control panel. Apply a non-
corrosive commercial bubble solution to the burner
jet orifice.
6. No bubbles should appear at the opening of the
burner jet orifice. The presence of bubbles indi-
cates a defective gas safety shut off, and service is
required.
7. If no bubbles were present at the burner jet orifice,
it should be rinsed with fresh water. Be careful not
to damage the burner jet orifice. Replace cover and
press the main power ON/OFF button (1) OFF and
back ON. Normal operation of the burner should
return. Allow the burner to operate for a minimum
of five minutes.
STEP 3: Two screws installed in the rear base.
See FIG. 8.
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet.
Any space between the counter, storage area or ceiling
and top of the refrigerator greater den 1-1/2 inches should
be blocked. The heat produced at the rear of the refrig-
erator will become trapped in this space, making the top
of the refrigerator hot and reduce the efficiency of the
refrigerator.
Drain water hose
A hole must be drilled through flooring see FIG. 8.
The hole must be drilled in the cut out opening of the
base plate at the rear of the refrigerator. The installer
MUST make sure that the hose does not kink when run
through the floor. Seal around the hose that goes through
the drilled hole. If a longer hose than supplied is required
to get the water to drain outside of the vehicle, the in-
staller will have to supply the extra length of hose.
Hole for drain
water hose
FIG. 8
FIG. 7