Filter
Top Products
21
If the hob is not working correctly, please carry out the following checks before contacting your local
Service ForceCentre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault
caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Something not working?
f SOLUTION
fHave the fuses replaced.
fReset the switches.
f Touch the main On/Off
Control
.
fOpen the tap.
f
Purchase a new bottle.
fAllow the top to cool (see
par. “Protection against
overheating”).
fDeactivate the Child Safety
function (see par. “Child
Safety Function”).
f
Wait 60 seconds, then
follow the instructions
given in chapter: “In case of
ignition failure”.
fCheck the correct position
(see par. “In case of ignition
failure”).
f Follow the instructions
given in the section
“Cleaning and
maintenance”.
f Contact an authorized
technical assistance centre
.
f See the section “How to
light a burner”
PROBLEM
THE HOB
DOESN’T
WORK
A BURNER
DOESN’T
WORK
IT TAKES TOO LONG
TO FINISH THE
DISHES / THEY
ARE COOKED
TOO FAST.
CAUSE
There are blown fuses in the
domestic electrical system.
Switches are turned off or
there is no power at the power
outlet.
The hob is not activated.
The main gas supply tap is
closed.
The gas bottle is empty.
The hob has overheated and a
safety device has been set on
the four burners.
The Child Safety function has
been inadvertently activated.
The safety device has been set
on the burner due to repeated
ignition failures. The flame
level indicators and the
residual heat indicator flash.
The pan support or the burner
cap and crown were not
correctly positioned after
cleaning.
The burner crown holes are
obstructed.
The defect persists.
The flame level adjustment is
not appropriate.