Filter
Top Products
33
Setting the hob for the new
gas type
1. If necessary, activate the hob by touching
the main ON/OFF Control for about 3
seconds.
2. Touch the Timer Control repeatedly to
select the auxiliary burner (front left burner)
on the burner selection display .
3. Touch the Increasing Control and hold
the finger on it until the value 99 appears
on the time display. Then, touch the
Decrasing Control and hold the finger
on it until the value 80 is displayed.
4. Then, touch the Increasing Control until
83 is displayed. At this point, the hob is set
to the “Gas Change” mode and the current
gas setting appears on the display:
- n0 stands for gas G20 (20 mbar)
- n1 for gas G30 (28-30/37 mbar).
IMPORTANT: setting n2 does not allow
the hob to function.