Filter
Top Products
5958 992 00
EN
31
1) Press the PROGRAM button:
2) Select the required program and press the button P2 ( )
to confirm. To cancel, just return to PROGRAM mode.
3) Press the START/STOP button to start the selected program.
To exit, modify or skip phase, refer to the sections on manual
control (MANUAL).
5. SETTINGS BASIC DATA
To set or display the Basic Data, proceed as follows:
1) Switch the oven on by pressing the button I (O - I).
2) Press the button P4.
SETTINGS
_________________________________________________________
CLOCK
LANGUAGE
COMMUNICATION
CHANGE PASSWORD
OVEN STATUS
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________
- TIME AND DATE -
• Press the button P3 (
) to enter the CLOCK page.
CLOCK
________________________________________________________
TIME AM * 08
MINUTES
40
DAY
14
MONTH
09
YEAR
05
FORMAT TIME
AM/PM *
________________________________________________________
* 24h (hours) or
AM/PM (AM = Ante Meridiem) (PM = Post Meridiem)
4) turn knob K to increase or decrease the value
(e.g. 8:00 selected, in the morning AM of September 14 2005)
5) press the button P2 (
) to select the other data to be modified
(going from hours to minutes)
Note:
To display the time, press the button P1 ( ) when the oven is
inactive.
- LANGUAGE -
• Press the button P2 ( ) to select the item LANGUAGE and
P3 ( ) to confirm.
• Press the button P2 ( ) again to select the required language
and P3 (
) to confirm it (some languages are on the next page,
therefore continue after the last item on the list to change page).
LANGUAGE
________________________________________________________
ENGLISH <<<<
ITALIANO
DEUTSH
................
.....................
..........................
________________________________________________________
ENGLISH is selected in the example.
• Press the button P4 ( ) to exit.
6. MODIFYING SET PARAMETERS
With the cooking cycle stopped , started or stored, operate the
relevant controls to modify the following parameters:
MANUAL
1) cooking mode;
2) cooking temperature
;
3) cooking time ;
4) core probe temperature
(alternatively to cooking time).
AUTOMATIC
1) Cooking level.
Note:
- When modifying the parameters of a STORED program the new
memorization will delete the previous one.
To modify the next phase during the cooking cycle with several
phases, the following operations must be carried out:
a) Press the START/STOP button to stop the cooking cycle in
progress.
b) Press the button P2 (
) and turn knob K to display the rel-
evant phase, modify the required values, setting them again.
c) Press the START/STOP button to resume the cycle in progress.