Filter
Top Products
10
Operation
Halogen Bulbs
This range hood requires two halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4 Base).
To change bulbs:
1 Open the cover by prying from the proper slots.
2 Remove the bulb by pulling sideways. (DO NOT ROTATE).
3 Replace with Type JC, 12Volt, 20 Watt Max, G-4 Base halogen bulb. Do not
touch replacement bulb with bare hands!
Fuse Placement
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE SERVICE
ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.
1 Raise or remove the lower decorative flue. See Figure 3.
2 Remove the cover from the electrical box.
3 Unscrew the cap from the fuse holder and remove the fuse.
4 Replace the fuse with the same size and amperage (5 x 20mm, 4 amp,
125 volt).
5 Reinstall the fuse holder cap, electrical box cover and flue.
6 Reconnect power at the service entrance.
WARNING
Always switch off the electrical supply before carrying out any operation on the appliance.
CAUTION
Bulb may be hot.
CAUTION
Use of bulbs greater than 20 watts will cause the fuse to open.
CAUTION
Use of a fuse greater than 4 amps may damage the transformer.
ELECTRICAL
BOX
FUSE
Figure 2
Figure 3