Filter
Top Products
17
Installation
Non-Ducted Hoods Only
1 Remove the tape on the electrical system plate; place the electrical system plate
on the hood (use a protection). Figure 12
2 Discard discharge collar/damper supplied with the hood. Install the 5” to 6” adapter
supplied with the Non-Ducted Recirculation Kit.
3 Secure the plenum to the flue mounting bracket with (2) 3.9x6mm flat head
screws (the screws are supplied with the Non-Ducted Recirculation Kit Model
DFKTWC40EC). Figure 13.
ELECTRICAL
SYSTEM
PLATE
PROTECTION
3.9x6mm
FLAT HEAD
SCREWS
PLENUM
FLUE MOUNTING
BRACKET
5”-6”
ADAPTER
Figure 12
Figure 13
NOTE
The following materials must be purchased separately for non-ducted recirculation
installations.
• Non-Ducted Recirculation Kit Model DFKTWC40EC.
• 5” diameter duct.