Filter
Top Products
9
Getting Started
OPERATING YOUR HOOD
Controls
The hood is operated using the (5) push-buttons located at eye-level, on the front
edge of the hood.
The light switch turns the halogen lights on and off. Push the light switch once to
turn the lights ON - push a second time to turn the lights ON to a brighter level
- push a third time to turn the lights OFF.
The blower on-off / speed 1 switch turns the blower on to its
lowest running speed. To turn OFF the blower, push in and
hold this blower switch for approximately 2 seconds.
The blower speed 2 switch turns the blower on to medium-low
running speed. Pressing this switch a second time sets a timer
which keeps the blower operating at this speed for 10 minutes.
The LED will blink during this time and the blower will shut off
automatically.
The blower speed 3 and blower speed 4 switches operate the
same as blower speed 2 switch except:
Blower speed 3 is medium-high and blower speed 4 is high.
After every 30 hours of operation, the LED above the “blower
speed 1 switch” will be illuminated (RED) and blink for 30
seconds after turning off the blower. This is a reminder to
clean the grease filters. Once the grease filters are cleaned
and installed, press in and hold the “light switch” button for approximately 2
seconds during the blink of the LED.
IMPORTANT
Do not operate the vent system without the filters in place or with dirty, grease-laden filters.
Figure 1