Filter
Top Products
20
Installation
INSTALL THE FILTERS
Ducted and Non-Ducted Hoods
1 To remove the GREASE filter, push in on the metal latch tab and tilt filter downward
to remove.
2 To install the GREASE filter, align rear filter tabs with slots in the hood. Depress
the metal latch tab, push filter into position and release. Make sure filter is securely
engaged after installation.
Non-Ducted Hoods Only
1 To remove the CHARCOAL filter, push in on the front filter latch. Pull the filter down
to disengage the rear filter tabs.
2 To install the CHARCOAL filter, align the rear filter tabs with slots in the hood. Push
the filter up into place until the front latch snaps securely into the slot. Make sure
the filter is securely engaged after assembly.
3 Install GREASE filter after charcoal filter is installed.
GREASE
TABS
LATCH
NON-DUCTED
RECIRCULATION
FILTER
Figure 18
Figure 19
NOTE
Prior to use, remove protective film from the filter frame.