Filter
Top Products
22
Cleaning the Spray Arm & Filter plate
Ensure the DishDrawer® is cool before you start
cleaning and follow the instructions for removing
the drain filter and spray arm.
1
Remove the basket carefully. Lift from the back
end first to prevent knocking the detergent and
rinse aid dispenser.
2
Lift the spray arm and shake any foreign material
out.
Rinse the spray arm under clean running water and
wipe the with a damp cloth.
3
In the centre of the filter plate there are two rings.
Hold the centre ring still and turn the outer ring
anti-clockwise, about a 1/8 turn. This will release
the filter plate.
4
Lift the filter plate.
When cleaning the underside of the filter plate,
take care handling the sharp outer edge to avoid
the risk of cuts.
Remove any foreign material, wash in hot soapy
water and rinse thoroughly in clean water. The
heater plate can be wiped with a damp cloth.
5
Replace the filter plate so it lies flat in the base of
the drawer ensuring the filter plate is fully locked
into position with the centre ring.
6
To lock the filter plate into position, ensure the
lines align with each other (refer to the diagram for
the correct position). The filter plate must not be
able to move about freely.
7
Replace the spray arm back onto the impeller.
8
Replace the basket, lowering the front edge of the
basket into position first.
Note
Where there is broken crockery or glass in the drawer, it must be carefully removed to prevent
damage to the DishDrawer®.
Correct Locking Position of
Filter Plate with Motor Assembly
(under Spray Arm)
a Outer Ring
b Impeller
c Correct Alignment marks
d Centre Ring
d
c
b
a