Fisher & Paykel DS603 Dishwasher User Manual


 
23
Trouble shooting
Problem Possible Cause What to do
Continuous
beeping
A fault has occured. Refer to the Fault codes section.
Intermittent
beeping
DishDrawer® is in pause
mode.
Close the DishDrawer® and press the
button.
DishDrawer® will
not start
Power supply is not
connected.
Connect the power supply.
The drawer is not properly
closed.
Ensure the drawer is firmly closed.
Lock feature is on.
Turn the Lock off. Hold down the
/ button until the symbol
disappears from the LCD screen or
the light above the
/ button
disappears.
button not pressed. Press the button.
Excess water in
the DishDrawer®
Drain hose(s) bent or
kinked.
Straighten the drain hose(s).
Blocked filters and/or drain
hose(s).
Clean the filter plate/drain filter. Unblock
the drain hose(s). Refer to the user
maintenance section.
Water marks on
the dishes
Insufficient rinse aid. Ensure there is enough rinse aid in the
dispenser.
Rinse aid setting too low. Increase the rinse aid setting.
DishDrawer® overloaded/
incorrectly loaded.
Refer to the section on loading.
Dishes did not
dry
Incorrect loading. Ensure the dishes are not nesting
together.
Rinse aid depleted. Refill the rinse aid dispenser.
Rinse aid setting too low. Increase the rinse aid setting.
Eco wash programme used. Choose a standard wash programme.
No detergent
dispensed
Detergent was wet when
loaded.
Clean the dispenser and ensure the
dispenser is dry when adding detergent.
Excessive motor
noise
The filter plate and/or spray
arm is incorrectly placed.
Refer to the user maintenance section
for details on correct placement.
No water in the motor area. This usually occurs on the first use or
when the DishDrawer® has not been
used for long periods of time. Run
the DishDrawer® through a wash
programme.