Filter
Top Products
5
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk
of electric shock by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more pro-
tected electrical supply. It is recommended that a separate circuit serving only this
appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded. Should you only have a 2-prong
outlet,haveaqualiedelectricianinstallacorrectwallreceptacle.
A 3-prong adapter may be purchased and used temporarily if local codes allow.
Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled in or
tripping over a longer cord.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that
has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on
the microwave oven. The marked rating of the extension cord should be AC 115-
120 volt, 15 amp. or more.
Be careful not to drape the cord over the countertop or table where it can be pulled
on by children or tripped over accidentally.
Notes:
1. If you have any questions about the grounding or electrical instructions, consult
aqualiedelectricianorserviceperson.
2. Neither DCS by Fisher & Paykel nor the dealer can accept any liability for damage to the oven or personal injury
resulting from failure to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position
and signal of receiving antenna.
C
4"
4"
6"
A
B
Theoorshouldbelevelforproperoperationofthe
oven. Be sure to check the local building code as it may
require that the opening be enclosed with sides, ceiling
and rear partition. The proper functioning of the oven
does not require the enclosure.
The Trim Kit includes all the necessary parts (including
simulated frames that match the MO-24SS microwave
oven) and easy-to-follow instructions for installation as
well as location of the power supply.
The ease of assembly for these kits will allow installa-
tion into an existing wall opening in less than an hour
(if power outlet is already properly located).
All it takes are four steps and a Phillips screw driver.
Outlet should NOT be in the shaded area as indicated.
1. If the dimension of DEPTH (C) is more than 21", the
outlet location may be any area on the rear wall.
2.Theooroftheopeningshouldbeconstructedof
plywood strong enough
to support the weight
oftheovenandoor
load (about 100 pounds).
Unpacking and I nstallation I nstructions
G rounding I nstructions