Filter
Top Products
38
Care and cleaning
Pyrolytic self-clean troubleshooting
1
The self-clean cycle has been cancelled by turning the function knob to O.
What to do:
Wait for the door to unlock. This happens automatically when the temperature inside the oven
drops below 300
O
C.
Wait for the oven to cool down completely before using it again.
2
The self-clean cycle has been cancelled by turning the function knob to a cooking function.
The selected cooking function will start.
What to do:
Turn the function knob to O
Wait for the door to unlock. This happens automatically when the temperature inside the oven
drops below 300
O
C.
Wait for the oven to cool down completely before using it again.
3
The self-clean cycle has been cancelled by a power cut.
What to do:
Turn the function knob to O
Wait for the door to unlock. This happens automatically when the temperature inside the oven
drops below 300
O
C.
Set the clock
Wait for the oven to cool down completely before restarting the self-clean cycle.
4
‘door’ shown in the display
The door is open or not properly closed when the pyrolytic cycle was selected.
What to do:
Close the door. Turn the function knob to O and start again.
If after 5 minutes the door has not been closed ‘door’ flashes and a beep sounds for 30 seconds.
What to do:
Close the door, press any button to silence the beeping and start again.
PYROLYTIC MODELS