Filter
Top Products
9
Dotted line showing the position
of the cooker when installed
min 95 - max 110
(depending on feet height adjustment)
75
=
=
0
+15
Installation instructions
FOUR FUNCTION MODELSGAS COOKTOP MODELS
Fitting the anti-tilt bracket
(seven-function models)
Important!
To restrain the appliance and prevent it tipping
accidentally, fit a bracket to its rear to fix it
securely to the wall. Make sure you also fit the
supplied lock pin to the anti-tiit bracket.
To fit the anti-tilt bracket:
1
After you have located where the cooker
is to be positioned, mark on the wall the
place where the two screws of the anti-tilt
bracket have to be fitted. Please follow the
indications given in Fig.6a.
2
Drill two 8 mm diameter holes in the wall
and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not
damage any pipes or electrical wires.
3
Loosely attach the anti-tilt bracket with the
two screws supplied.
4
Move the cooker to the wall and adjust the
height of the anti-tilt bracket so that it can
engage in the slot on the cooker’s back, as
shown in Fig.6a.
5
Tighten the screws attaching the anti-tilt
bracket.
6
Push the cooker against the wall so that the
anti-tilt bracket is fully inserted in the slot
on the cooker’s back.
7
Access the bracket and fit the lock pin;
Remove the drawer (Fig. 6b).
Fit the lock pin through the bracket,
as shown (Fig.6c).
Refit the drawer.
Fig. 6c Fitting the lock pin through the bracket
1
Anti-tilt bracket
attached on the
rear wall
Cooker’s
back
Lock pin
Slot on the
cooker’s back
2
Fig. 6b Removing the drawer
Fig. 6a Fitting the anti-tilt bracket
Lock pin
correctly tted
1
2
3
4