Filter
Top Products
7
Installation instructions
Levelling the cooker
Important!
Using the supplied adjustable feet is MANDATORY.
For safety reasons and to ensure adequate
ventilation, the cooker chassis MUST NOT sit
directly on the floor, a plinth, or other support
surface.
To fit the adjustable feet:
1
Rest the rear of the cooker on a piece of
packaging, exposing the base for fitting the
feet.
2
Screw the four feet to the cooker.
3
Stand the cooker and level it by screwing
or unscrewing the feet with an adjustable
spanner. Use the supplied nuts if necessary.
See Figs. 3a and 3b.
Fig. 2 Fitting the adjustable feet
(supplied with the cooker in the feet kit)
0
+ 8
mm
+ 8 mm
+ 15 mm
Fig. 3b Use the supplied nuts for height
adjustments between 8 and 15 mm
Fig. 3a Do not use the supplied nuts for height
adjustments between 0 and 8 mm
FOUR FUNCTION MODELSGAS COOKTOP MODELS
Fig. 4 Assembling the backguard
(seven-function models only)
AA
B
Fixing the backguard
(seven-function models only)
Before installing the cooker, assemble the
backguard “B”.
The backguard “B” can be found packed at the
rear of the cooker.
1
Before assembling, remove any protective film/
adhesive tape.
2
Remove the three screws “A” from the rear of the
cooktop.
3
Assemble the backguard as shown and fix it by
screwing the three screws “A”.