Filter
Top Products
18
CARE AND MAINTENANCE
REPLACE INTERIOR LIGHT BULB
When supplied with an interior light, your refrigerator uses a 15 Watt appliance light bulb. To replace the light
bulb, proceed as follows:
1. Unplug the power cord from the power supply.
2. Open the cabinet door, the light bulb is located behind the display housing at the top of the unit.
3. Unscrew the existing bulb and replace with an equivalent 15 Watt, threaded, intermediate base appliance bulb.
Do not replace with a bulb higher than 15 Watts.
THINGS TO REMEMBER. . .
1. Allow 24 hours for your refrigerator to reach a new temperature setting.
2. The motor will start and stop often. It must do this to maintain the temperature you select.
3. Keep your refrigerator reasonably level.
4. Unplug the refrigerator before working on anything with the electrical system.
5. Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grill and/or
the light fixture switch can occur.
6. For all cleaning of the refrigerator interior, mix 2 tablespoons baking soda with 1 quart warm water or use mild
soap. Do not use strong cleaners or scouring powder or pads.
7. Keep your refrigerator out of direct sunlight.
8. Do not splash or spray water on or under the refrigerator.
9. Clean your refrigerator’s condenser periodically to maintain proper cooling performance.
ENERGY SAVING TIPS
1. Reduce door openings.
2. Close the door as soon as you can.
3. Keep the coils on bottom of the refrigerator clean.
4. Adjust the temperature control to a warmer setting when practical.
5. Don’t put hot foods in the refrigerator.
6. Keep unit away from the stove or other heat sources.