Franklin Industries, L.L.C. fim35 Ice Maker User Manual


 
50ºF (10ºC) and below 100ºF (38ºC). This unit MUST be installed in an area
protected from the elements, such as wind, rain, water spray or drips.
The ice maker should not be located next to ovens, grills or other sources of high heat.
The ice maker must be installed with all electrical and water connections in
accordance with state and local codes. A standard electrical supply (115 VAC only,
60 Hz, 15 A), properly grounded in accordance with the National Electrical Code and
local codes and ordinances is required.
Do not kink or pinch the power supply cord or drain lines between the ice maker and
the cabinet.
The fuse (or circuit breaker) size should be 15 amperes.
It is important for the ice maker to be leveled in order to work properly. You may
need to make several adjustments to level it.
All installations must be in accordance with local plumbing code requirements.
Make certain that the hoses are not pinched or kinked or damaged during installation.
Check for leaks after connection.
Although the unit has been tested at the factory, due to long-term transit and storage,
the first batch of cubes must be discarded.
Remove the packing materials and clean the ice maker before using.
Turn on the water supply tap before switching on the ice maker. Never turn the water
supply tap off when the ice maker is working.
Except to take ice from the unit, keep the door closed in order to reduce ice melting
and to promote proper ice formation.
If the ice maker will not be used for a long time, before the next use it must be
thoroughly cleaned. Follow carefully any instructions provided for cleaning or use of
sanitizing solution. Do not leave any solution inside the ice maker after cleaning.
DO NOT touch the condenser fins. The condenser fins are sharp and can be easily
damaged.
DO NOT use solvent-based cleaning agents or abrasives on the interior. These
cleaners may transmit taste to the ice cubes, or damage or discolor the interior.
The ice machine cleaner contains acids. DO NOT use or mix with any other
solvent-based cleaner products. Use rubber gloves to protect hands. Carefully read the
material safety instructions on the container of the ice machine cleaner.
Do not use this apparatus for other than its intended purpose.
SAVE THESE INSTRUCTIONS
4