Filter
Top Products
16
Self-Cleaning
To Start the Self-Clean Cycle
The SPEED CLEAN
Speed
clean
, CLEAN
Clean
and MAXX CLEAN
Maxx
clean
pads control the Self-
Cleaning feature. If you are planning to use the oven directly after a self-clean cycle
remember to allow time for the oven to cool down and the oven door to unlock. This
normally takes about one hour. So a 3 hour self-clean cycle will actually take about 4
hours to complete.
*It is recommend to use a
Speed
clean
cycle (2 hour) for light soils, a
Clean
cycle (3 hour) for
average soils, and a
Maxx
clean
cycle (4 hour) for heavy soils (to assure satisfactory
results).
NOTE: During a Self-Cleaning cycle the second oven will be disabled.
To avoid possible
burns use care when opening the
oven door after the Self-Cleaning
cycle. Stand to the side of the oven
when opening the door to allow hot
air or steam to escape.
DO NOT force the
oven door open. This can damage
the automatic door locking system.
Use caution and avoid possible
burns when opening the door after
the Self-Cleaning cycle has
completed. The oven may still be
VERY HOT.
To set the controls for a 3 hour Self-Cleaning cycle
to start immediately and shut off automatically
1. Be sure the clock is set with the correct time of day and the oven
door is closed.
2. Press
Clean
. "CLEAN", "1" and "TIME" will flash in the display
(Figure 1). The control will automatically clean for a 3 hour period
(default self-cleaning cycle time). Note: If a 2 or 4 hour clean time
is desired, press
Speed
clean
for 2 hour or press
Maxx
clean
for a 4 hour clean
time. Set the cleaning time based on the amount of soil: light,
medium or heavy (* See above).
3. Press
START
.Once the door has locked, "CLEAN", "LOCK" and
"
ON
" will appear in the display (Figure 3).
4. When flex clean finishes, lock will remain in the display until the
door has unlocked (Figure 4).
Note: Allow about 15 seconds for the oven door lock to close.
When the Self-Clean Cycle is Completed
1. The time of day and "LOCK"will remain in the display (Figure 4).
2. Once the oven has cooled down for approximately 1 HOUR, and
"LOCK" is no longer displayed, the oven door can then be opened
(Figure 5).
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle due
to excessive smoke or fire in the oven:
1. Press
Clear
/Off
.
2. The oven door can only be opened after the oven has cooled down
for approximately 1 HOUR, and "LOCK" is no longer displayed
(Figure 5).
INSTRUCTIONS PRESS DISPLAY
Clean
Speed
clean
or
Maxx
clean
START
Clear
/Off
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
CLEAN
CLEAN
CLEAN
1
TIME
TIME
CLEAN
CLEAN
CLEAN
1
TIME
TIME
CLEAN
CLEAN
LOCK
ON
OVEN
OVEN
1
TIME
TIME
LOCK
NOTE: A smoke eliminator in the
oven vent converts most of the soil
into a colorless vapor.