Filter
Top Products
2
TIME
TIME
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Setting the Clock
Setting the Clock
The CLOCK
Clock
pad is used to set the clock. The clock may be set for 12 or 24 hour time
of day operation. The clock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press
Clear
/Off
. A beep will sound and PF will disappear.
To set the clock (example below for 1:30)
1. Press
Clock
. "TIME" will appear in the display (Figure 2).
2. Press
1
3
0
pads to set the time of day to 1:30 (Figure 3).
"TIME" will stay in the display. Press
START
. "TIME" will disappear
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
Clock
for 7 seconds (Figure 3). After 7 seconds,
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display and
the control will beep once.
2. Press
Clean
to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
3. Press
START
or
Clear
/Off
or wait 5 seconds to accept the change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Clock
1
3
0
START
Clock
for 7 seconds
Clean
START
or
Clear
/Off
INSTRUCTIONS PRESS DISPLAY