Filter
Top Products
5-3
WATER NOT
HEATING. AUTOFILL
WORKED PROPERLY.
Press the
Temperature
Check button twice
to display setpoint.
Is the
displayed setpoint
correct?
Enter correct setpoint in
accordance with
instructions in Chapter 3.
Did burners
light?
Did water
reach setpoint
temperature?
Problem
resolved.
Refer to troubleshooting
guide "BURNERS DO NOT
LIGHT".
Insert a good grade thermometer
into cookpot with tip near the
temperature probe and wait two
minutes. Press the Temperature
Check button once to display the
cookpot temperature.
Is the temperature
displayed reasonably close to
the thermometer
reading?
Temperature control
features are working properly.
If water still fails to reach
setpoint, call FASC.
There is a problem in
the temperature probe
circuit. Call FASC.
Yes
No
Yes
No
No
Yes
No
Yes