Frymaster H20.5 SERIES Fryer User Manual


 
H20.5 SERIES ELECTRIC FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-6
3.2 Programming The Computer Magic III.5 (cont.)
3.2.1 Boil Feature
CAUTION
Do not drain water or boil-out solution into the filtration system (if applicable). Irreparable
damage will result and void the warranty.
1. Before switching the fryer "ON", close the frypot drain valve. Fill empty frypot with mixture of
cold water and detergent. Follow detergent instructions when mixing.
NOTE: Boil Mode will not turn on both sides of computer. Each side will have to be turned on
separately.
2. To program computer for Boil Feature, press either switch.
3. Press the switch. will appear in the left display.
4. Enter 1, 6, 5, 3 in that sequence. The right display will read . The temperature is
automatically set for 195°F (91°C). The fryer will attain this temperature and remain there until
either switch is pressed, which cancels the boil-out mode. In high-altitude locations,
constantly monitor the fryer for over-boil conditions. If over-boil occurs, turn off fryer
immediately, allow to cool, and re-enter boil-out mode to continue the boil-out operation.
3.2.2 Fryer Recovery Time Check
Recovery Time - An acceptable recovery time is 100 seconds or less.
1. To check recovery time, press the switch. will appear in the left display.
2. Enter 1, 6, 5, 2 in that sequence. The recovery time will appear in both displays for 5 seconds.
3.2.3 Temperature Selection—Fahrenheit to Celsius
1. To change the computer temperature from Fahrenheit to Celsius or Celsius to Fahrenheit, press
either
switch.
2. Press the
switch. will appear in the left display.
3. Enter 1, 6, 5, 8 in that sequence. The computer will automatically convert the temperature from
Fahrenheit to Celsius or Celsius to Fahrenheit.
4. Press the switch to display the temperature in the newly selected mode.