Filter
Top Products
HIGH EFFICIENCY DECATHLON (HD) SERIES GAS FRYERS
CHAPTER 5: CONTROLLER OPERATING INSTRUCTIONS
5–3
5.2 Electronic Thermostat Controller/Computer (cont.)
MAIN POWER SWITCH – connects/disconnects primary power; double-lighted with center
position "OFF". One main switch controls two electronic thermostats/Compu-Fry or remote
computers. When the main power switch is in the center position, power is removed from the two
fryers controlled by the electronic thermostats/Compu-Fry or remote computers. When the main
power switch is pressed to the right, power is supplied to the electronic thermostat/Compu-Fry or
remote computer of each fryer.
INDIVIDUAL FRYER POWER SWITCH – this switch controls power to the individual fryer.
When the power switch is in the "ON" position, the indicator light will be lighted when calling for
heat. The power switch only removes power from the temperature control circuit (electronic
thermostat controller). The power switch should be in the "OFF" position during filtering.
BOIL-OUT SWITCH – operates only when the electronic thermostat controller is enabled.
When the boil-out switch is "ON", it will bypass the melt cycle, and allow the water temperature to
reach approximately 196°F (91°C).
HIGH-LIMIT RESET – this reset button is located under each individual control panel, and must
be manually reset if the fryer exceeds high-limit setpoint.
FILTER RESET BREAKER (7 amp circuit breaker- 120VAC, or 5 amp circuit breaker- 230VAC)
– the breaker is in line between the filter switch and the pump. Ensure filter power is off prior to
resetting or replacing.
5 AMP (115VAC) or 2 AMP (230VAC) FUSE – each fryer circuit is protected by a 5 amp
(115VAC) or 2 amp (230VAC) fuse located under the control panel.