Filter
Top Products
C141-E124-01EN5 - 18
Table 5.3 Sense data error classification (3 of 4)
K
*
C
*
Q
*
Outline of Error L
*
Recovery Method
(See Table 4.4.)
6 2A 01 Mode parameters changed None 21
The MODE SELECT parameters were changed by
another INIT.
6 2F 00 Commands cleared by another INIT None 25
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed None 27
02 Changed operation definition
6 5B 01 Log exception (Threshold condition met) None 26
The current cumulative value exceeded the current
threshold value.
02 Log count at maximum
The current cumulative value reached the maximum
value.
6 5C 01 Spindle synchronized None 22
Rotational synchronization was completed.
6 5C 02 Spindle not synchronized None 23
Rotational synchronization deviated.
7 27 00 Write protected None 15
Access to a read protected or write protected.
7 2C 00 Command sequence error None 2
The SET LIMITS command was issued 2 times
within a group of commands linked in a series.
B 03 xx Peripheral device write fault Need 12
11 xx Unrecovered read error
13 xx Sync byte not found for data field
14 xx Record not found
15 xx Mechanical positioning error
B 43 00 Message error Need 6
45 80 Select/Reselect failure
47 00 SCSI parity error
48 00 INITIATOR DETECTED ERROR message received
49 00 Invalid message error
An unrecoverable SCSI related error occurred in
the command execution sequence.
B 4E 00 Overlapped commands attempted None 2
Before execution of a command was completed, a
new command was issued by the same INIT.
4D nn Tagged overlapped commands
* K: Sense Key C: Sense Code
Q: Sub-sense code L: Logging Necessary? (shown in Section 5.2.3)