Filter
Top Products
C-
Ck
To Set the Clock
3
,,ti
clock
must be set
for
the
automatic oven timing functions to
work properly.
The
time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
❑
1.
Press the
CLOCK pad.
CLOCK
A
A
2. Press the
INCREASE or
@
DECREASE pad
to set the time
of day.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The
[imer
is a
minute
timer; it does
not control
oven
operations. The
maximum setting on the timer is
9
hours and 55 minutes.
❑
1.
Press the TIMER
TIMER
ON/OFF pad.
ON/OFF
A
2. Press the INCREASE or
DECREASE pad to set the
amount
of
time on the timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad
The timer, as you are setting it,
will display hours and minutes
“HR”
will
be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
r
Reset the Timer
To Cancel the Timer
11 TIMER” is displayed, press the INCREASE or
Press and hold the TIMER ON/OFF pad until the
DECREASE pad until desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The End of
Cycle
tone is a series of
3
beeps followed by
1
beep every
6
seconds. If you would
like
to remove the signal that beeps every 6
seconds, press and hold the CLEAR/OFF pad for 1() seconds.
To return the signal that beeps every
6
seconds, press
and
hold the
CLEAWOFF
pad
for
10
seconds.
Power Outage
After a power outage, when power is restored, the display will flash
and
time shown will no longer be correct—for example, after a 5-minute power
interruption the
clock
will
be 5 minutes slow.
All other functions that were in operation when the power went out will
have to be programmed again.
((c)lltill[(c,{l
jle.rt
/ILIg<,)