Filter
Top Products
How
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid resistant. How-
ever, any acid foods spilled (such
as fruit juices, tomato, or vinegar)
should not be permitted to remain
on the finish.
jA!c21==L)gyo
x-
-=
J! (’7J~
I
OVEN VENT OUCT
/ ,----------
.-
,
\
,
Your oven is vented through an
opening located under the center
of the control panel.
During most operations it is normal
to observe moisture and/or vapor
emitting from opening. Clean this
area frequently.
NOTE: NEVER COVER OR BLOCK
VENT OPENING. TO DO SO PRE--
VENTS THE OVEN VENT FROM
FUNCTIONING PROPERLY DUR-
ING COOKING OR SELF-CLEAN-
ING OPERATIONS.
Lamp and
CAUTION: Before replacing your
oven bulb, disconnect the elec-
trical power for your range at the
main fuse or circuit breaker panel
or pull plug. Be sure to let the la,mp
cover and bulb coo! completely
before removing or replacing,
To Remove:
@Remove the 3 siotted screws in
the lamp cover as shown in
diagram,
@Detach lamp
bulb.
,To Replace:
@
o
0
cover and remove
Put in a new
bulb.
Install lamp
40-watt appliance
cover. Replace 3
screws and tighten, making sure
cover fits flush with oven wall.
Reconnect electrical power to
the range.
WHEN CHANGING A COOKTOP
LAMP, DO NOT TOUCH THE
METAL AT ENDS OF LAMP,
a. Remove Phillips head screws at
each end of cover.
b. Place finger% on top near each
end of lamp. Press down and roil
top of lamp gently toward front of
range until it stops. Remove.
c. Check type and wattage of
lamp; replace with same kind.
Hold lamp near each end and in-
sert prongs into sockets. Gently
roll top of lamp toward rear of
range until it stops.
CLReplace lamp cover and screws.
e. Connect electric power to range,
14
Use time given on recipe when
cooking first time. Oven thermo-
stats, in time, may “drift” from the
factory setting and differences in
timing between an old and a new
oven of 5 to 10 minutes are not
unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brww too little or too much, you
may make a simple adjustment in
the thermostat (Oven Temp) knob.
PULL KNOB OFFOFSHAFT, LOOK
AT ‘BACK OF KNOB AND NOTE
CURRENT SETTING, BEFORE
MAKING ANY ADJUSTMENT.
To increase temperature, turn
toward RAISE; to decrease turn
toward LOWER. Each notch
changes temperature 10 degrees.
Temperature can be raised by 20
degrees or lowered by 30 degrees.
1. Remove knob, and hold so
pointer is at top of knob, Using a
=
pot holder or similar material, hold
“skirt” of knob firmly in one hand.
Grasp handle of knob in other hand.
Note position of pointer and turn
handle to move pointer toward
Raise or Lower. Pointer is designed
not to move easily. If it is seated so
it is difficult to move, pointer may
be loosened slightly. Insert a thin
screwdriver, knife blade or similar
instrument and lift up end of
pointer slightly.
2. After adjustment is made, press
monitor firmly against knob. Return
knob to range, matching flat area
on knob and shaft. Recheck oven
performance before making an
additional adjustment.
-—