GEAppliances.com
Safety Instructions
Operating
Instructions
Care and Cleaning Troubleshooting Tips Consumer Support
15
START Pad
Must be touched to start any cooking or cleaning function.
OVEN LIGHT Pad
Touch to turn the oven lights on or off.
TIMER ON/OFF Pad(s)/KITCHEN TIMER Pad
Touch to set the kitchen timer.
See the Using the Kitchen Timer section.
COOK TIME/COOKING TIME Pad
Touch this pad and then touch the number pads to set the
amount of time you want your food to cook. The oven will
shut off when the cooking time has run out.
DELAY START Pad
Use along with the COOK TIME or SELF CLEAN pads to set
the oven to start and stop automatically at a time you set.
CLOCK Pad
NOTE: When setting times, you are setting hours and minutes
only. The lowest time you can set is one minute.
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
The clock must be set to the correct time of day for the
automatic oven timing functions to work properly. The time of
day cannot be changed during a timed baking or self-cleaning
cycle.
If your oven was set for a timed oven operation and a
power outage occurred, the clock and all programmed
functions must be reset. The time of day will flash in the
display when there has been a power outage.
CONTROL LOCKOUT Pad
Your control will allow you to lock out the touch pads and the
cooktop so they cannot be activated when touched.
To lock the controls and cooktop:
Touch and hold the CONTROL LOCKOUT pad for 3 seconds.
The oven display will show “on Loc on.”
To unlock the controls:
Touch and hold the CONTROL LOCKOUT pad for 3 seconds.
The CONTROL LOCKOUT mode affects all touch pads.
No touch pads will work when this feature is activated.
WARMING DRAWER
The warming drawer will keep hot, cooked foods at serving
temperature. Always start with hot food.
Touch the WARMING DRAWER pad. “WARMER ON” and “1”
are lit on the display and “Set” begins to blink. On the number
pads, touch 1 for Low, 2 for Medium or 3 for High. The display
“1” changes corresponding to the number pad selected. The
warming drawer starts automatically after you touch 1, 2 or 3.
“WARMER ON” and the number remain lit. “Set” stops blinking.
On some models, press START.
On some models – toggle between settings by touching the
WARMING DRAWER pad.
To cancel, touch the WARMING DRAWER pad.
NOTE: Touching the CLEAR/OFF pad does not turn off the
warming drawer.
WARMING ZONE
Touch to keep hot, cooked food warm. See the Using the
Warming Zone section.