Filter
Top Products
Consumer Support Troubleshooting Tips Care and Cleaning
Operating
Instructions
Safety Instructions
Read all safety instructions before using the product. Failure to follow these instructions may result in fire, electric
shock, serious injury or death.
IMPORTANT SAFETY NOTICE
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
The fiberglass insulation in self-clean ovens gives off a very small amount of carbon monoxide during the cleaning cycle.
Exposure can be minimized by venting with an open window or using a ventilation fan or hood.
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
To reduce the risk of tipping the range, the range must be secured
by a properly installed anti-tip bracket. See installation instructions
shipped with the bracket for complete details before attempting
to install.
For Freestanding Ranges:
To check if the bracket is installed and engaged properly, remove
the storage drawer or kick panel and look underneath the range
to see that the leveling leg is engaged in the bracket. On models
without a storage drawer or kick panel, carefully tip the range
forward. The bracket should stop the range within 4 inches. If it
does not, the bracket must be reinstalled. If the range is pulled
from the wall for any reason, always repeat this procedure to
verify the range is properly secured by the anti-tip bracket.
Never completely remove the leveling legs or the range will not
be secured to the anti-tip device properly.
For Slide-In Ranges:
To check if the bracket is installed and engaged properly, remove
the storage drawer or kick panel and look underneath the range to
see that the leveling leg is engaged in the bracket.
For Drop-In Ranges:
To check if the bracket is installed and engaged properly, lower
the oven door and gently apply medium force at the handle end
until movement of the range is detected. Continue pressing until
the anti-tip bracket is engaged and movement stops. A small
amount of movement is acceptable at the back of the range top,
but it should be stable and not tip once the anti-tip bracket is
engaged. If it does not, the bracket must be reinstalled.
If you did not receive an anti-tip bracket with your purchase,
call 1.800.626.8774 to receive one at no cost (in Canada, call
1.800.561.3344). For installation instructions of the bracket,
visit GEAppliances.com (in Canada, GEAppliances.ca).
ANTI-TIP DEVICE
2
WARNING
WARNING