Filter
Top Products
Operating Instructions Safety InstructionsCustomer Service Troubleshooting Tips
Before you call for service…
32
Troubleshooting Tips
Problem Possible Causes What To Do
BAD PROBE appears
The probe has not been •Insert the probe properly into the receptacle.
on display
completely inserted into
the receptacle.
The probe is defective. •Replace the probe.
LOCKED appears
The control has been locked. •Press and hold
CLEAR/OFF
for about 3 seconds
on display
to unlock the control.
HOT—OVEN IS HOT
The temperature inside the •This is normal.
appears on display
oven is greater than 200°F.
One of the sensor cooking •These features will not operate when the oven is hot.
pads was pressed when the
temperature inside the oven
was greater than 200°F.
You hear an unusual,
You have tried to start the •Start over and enter a valid time of day.
low-tone beep
Reminder without a valid
time of day.
You have tried to change •Many of the oven’s features are preset and cannot be
the power level when it changed.
is not allowed.
Things That Are Normal With Your Microwave Oven
■Steam or vapor escaping from around
the door.
■ Light reflection around door or outer case.
■ Dimming oven light and change in
the blower sound at power levels other
than high.
■ Dull thumping sound while oven is
operating.
■ TV/radio interference might be noticed
while using the microwave. Similar to the
interference caused by other small
appliances, it does not indicate a problem
with the microwave. Plug the microwave
into a different electrical circuit, move
the radio or TV as far away from the
microwave as possible, or check the
position and signal of the TV/radio
antenna.