Filter
Top Products
—
❑
CONVERTING SURFACE BURNERS ON
MODELS EQUIPPED WITH SEALED BURNERS (See
Step 4 if
range
is equipped with dual burners.)
Burner Cap
Burner Head
Q
<
i
.
a
1. Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base.
~
burner
straight out.
DO
N~
disconnect the wires from the burner
bases unless the
cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
7mm
or 5/16” wrench (depending on the size of
your spuds).
Apply a 3/4” wrench to the hex
on
the
gas inlet tube as a back-up when
removing spud to prevent the aluminum
tube
horn
twisting.
4. Install orifice spuds
accordin to one of the
d
following diagrams (see ❑ or B ), for LP
gas or natural gas, depending on which you are
converting to.
❑
Orifice Spuds for
Convetiingto
LPGas:
LP orifice spuds are in a small plastic bag packed
with this Use and Care book.
LP or~lce spuds
have a 2-digit number and the Letter “L” on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
❑
Orifice Spuds for
Convetiingto
NaturaI
Gas:
Natural gas or~lce spuds have a 3-digit number
on one side. Each
otilce
spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
(continued next page)
45