Filter
Top Products
QUESTIONS?
USE THIS PROBLEM SOLVER
(continued)
PROBLEM
SURFACE
LIGHT DOES
NOT WORK
STRONG ODOR
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR
WEL
NOT
~LOCK
OVEN NOT CLEAN
A~R
CLEAN CYCLE
“DOOr”
APPEARS
ON DISPLAY
CONTROL BEEPS
A~ER
ENTER~G
OVEN
ME
OR
STOP
TfME
POSSIBLE CAUSE
*
Huorescent
bulb is loose
or
defective, Adjust or replace.
●
Switch operating light is broken.
Cdl
for service.
●
Improper
airJgas
ratio
in
oven+
Adjust oven burner air shutters.
“
An
odor
from the insulation
around
the
oven liner is normal for the first
few
times the oven is used. This is temporary.
●
Oven temperature is too high to set
self-claaning
operation. Allow the range to
cool to room
temperamre
and reset the controls.
*Door
latch
handle
not
moved
dl
the
way to the right.
●
Oven must
COQ1
below
locking
temperature clean cycle is complete. Do not
lock door with
door
latch except when using self-clean feature or the oven
may lock.
●
Oven
controls
not
set properly. Review Operating the Self-Cleaning Oven section.
*
Heavily soiled ovens
require
3~z
to
4
hour
clean
time.
●
Heavy
spillovers
should be cleaned
up
before starting clean cycle.
●
Self-cleaning
cycle
has
been
selected
but
latch
hande
was not moved all the
way to the right. Move the latch handle.
●
Latch
hande
was moved
to
the right but a program other than self-cleaning was
selected. Move the latch
handIe
to
the
right
only when setting self-cleaning cycle.
●
This is reminding you to enter a bake temperature (see Baking section).
If you need more
help...call,
toll free:
GE Answer Center
m
800.626.2000
consumer information service
50