Filter
Top Products
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt GE bulb
(WB02X4235)
available from your GE supplier.
I
.,
I
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About
1
tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
The
Exhamt
Feature
I
ME+AL
METAL
FILTER
FILTER
COO~P/NIGHT
LIGHT
The exhaust hood
feature on your
microwave oven is equipped with
two metal
fiIters
which collect
grease. When the fan is operated,
air is drawn up through the filters
and is then discharged through the
—
provided venting to the outside.
The hood also has a light for
illuminating the counter space.
When NIGHT LIGHT pad is
touched, the hood light operates
at a lower intensity for use as
a night light.
.
and to the front The filter will
drop out.
II
Never operate your hood without
the filter in place.
In situations
where flaming might occur on
surfaces below hood, filter will
retard entry of flames into the unit.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
To remove grease filter,
grasp the
of electric shock by providing an
“finger hold” on the filter and slide to
escape wire for the electric current.
the rear. Then pull filter downward
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
To replace grease filter,
slide the
filter in the frame slot on the back
of the opening.
Pull filter upward and to the front
to lock into place.
To clean grease filter, soak,
then
agitate filter in a solution of hot
water and detergent. Don’t use
ammonia or other alkali because it
will darken metal. Light brushing
can be used to remove embedded
dirt. Rinse, shake and remove
moisture before replacing.
Filters
should be cleaned at least once a
wARNING-Improper
use of the grounding plug
~an
~esult
in a risk of electric shock.
n
-,@
%
INSURE PROPER
GROUNO
EXISTS
Fig. 1
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
month.
Do not use an extension cord with
this appliance.
29