Filter
Top Products
Keep your oven
dm
and
sweet-
Wn’t
M
sharp+ed
uti
am~q
Opening the oven door
on
yom
oven. The inside and
a few minutes after
coobfok~p
outside oven walls can be
air out the inside. An
~.
scratched. The
contil
panel
through wiping with a solution
can be damaged.
of
bting
soda and water
bps
the inside fresh.
BE
CERTA~
POWER IS OFF
BEFORE
CLEA~G
W
PART OF
T~
OVEN.
W*
md
floor.
Some spatters
a
be removed
wifi
a paper towel, otiers may
~uire
a damp cloth.
Remove greasy spatters
witi
a
sudsy
cloth, then rinse
with a damp cloth. Do not use abrasive
claers
on
MMERcw
Om
oven walls. NEVER
USE A CO
CMANER
ON ANY
P~T
OF YOUR
mCROWAVE
OVEN.
Mr
(iAde).
Window: Wipe up spatters daily
and wash when soiled with a damp cloth. Rinse
AorougMy
and dry.
MeM
and plastic parts on door: Wipe
~uentiy
with a damp
C1O*
to remove
dl
soil. DO NOT USE
ABRAS~S,
SU~
AS C
~G
POWDERS
OR
S-
AND
U~C
PADS.
WY
-
DAMAGE
~
SURFACE.
S-note when
-
Brown
‘N*
M:
E
grease
is
presen~
high heat
generati
on bottom of
a
Brow
‘N Sear dish may cause the grease to bum
onto the oven tray. This may be removed with a
cleanser such as Bon
Ami”
brand cleanser.
After using Bon
Ami”
brand cleanser, rinse and dry
thoroug~ , following instructions on can. Do not use
.J
Bon
Anu
brand
c1
eanser
on the painted surfaces such
as the walls. It may scratch the paint.
Cm.
Clean the
oufiide
of your oven
witi
soap and
damp cloth, rinse with a damp cloth and then dry.
Wipe the window clean with a damp cloth. Chine
trim is best wiped with a damp cloth and then witi
a dry towel.
Control
Md.
Wipe with a damp cloth. Dry
*orougMy.
Do not use cleaning sprays, large amounts
of soap and water, abrasives or sharp
obj=ta on the
panel-they can damage it.
-r
Sd-
When cleaning surfaces of door and
oven that mme together on closing the
door, use only
dd,
non-abrasive soaps or detergents applied with a
sponge or
sofi
cloti.
Power
Cofi
If the
mrd
becomes
soilti,
unplug and
wash with a damp
cloti.
For stubborn spots,
sudsy
water may be used, but be
mrtain
to rinse with a
damp cloth and dry thoroughly before plugging
mrd
into
outiet.