Filter
Top Products
Compactor Top
Countertop Overlap
Step 5
Attach
tip-over
brackets
Position tip-over brackets on the top of the
compactor. Match hole #3 of the bracket to the screw
hole on the compactor (the 3rd hole on the bracket
is the standard location). Attach tip-over bracket to
compactor with one slotted head screw on each side.
• Remove the compactor drawer for easier handling.
• Then position the compactor just in front of the
cabinet opening.
• PLUG POWER CORD INTO THE WALL
RECEPTACLE.
• Slide compactor back into cabinet opening.
Note: Make certain that the
leveling feet caps are on the
leveling feet and the power
cable is not under compactor.
The short leg of anti-tip bracket should be completely
under the lip of the countertop but not so far back
that the screws can’t be put in. If the bracket is not in
the proper location, pull the compactor back out far
enough to get to the top screws and reposition the
bracket to the appropriate hole.
Drill (4) 1/8" dia. x 1/2" deep pilot holes in the
underside of the countertop at the location of the
four holes in the short leg of the anti-tip bracket.
Caution: Do not drill up through the top of the countertop.
Secure anti-tip bracket to countertop with 4 Phillips
head screws (supplied) on each side.
10
Installation
Built-In Compactors