5
3/4" Thick Wood Panel with custom handle
• Cut panel 12" wide x 25-13/16" high. A custom
handle, of your choice, can be installed onto the
3/4" wood panel, replacing the standard handle.
The cut edges of the custom panel can be seen
and must be finished for best appearance. The trim,
drawer front panel and the handle will be removed
to make this installation.
Note: 3/4" thick door panels, both raised and flat design,
should be constructed in the same manner as typical cabinet
doors. Order the 3/4" custom door panel from the cabinet
manufacturer. Be sure to provide the exact dimensions so
that the panel is constructed accurately. Order custom handle
to match cabinetry hardware.
Go to Step 7, page 14. Follow procedure D for
installation.
Follow national electrical codes
or prevailing local codes and
ordinances.
Note: The outlet location is critical for proper cord storage when
compactor is installed.
For personal safety, do not
use an extension cord or
adapter plug with this
appliance.
Do not, under any
circumstances, cut or remove
the third grounding prong
from the power cord.
Note: Usable power cord
length is 3 to 4 ft.
This appliance must be supplied with 120V, 60HZ
and connected to an individual, properly grounded
branch circuit protected by a 15 or 20 amp circuit
breaker or time delay fuse.
Install a 3-prong grounding type receptacle in the
rear wall of the cabinet opening.
25-13/16"
12"
3/4"
Pour votre sécurité
personnelle, n’utilisez pas
de rallonge ou de fiche
d’adaptation avec cet
appareil.
Ne coupez ou n’enlevez pas,
pour quelque motif que ce
soit, la troisième broche
de masse du cordon
d’alimentation.
CAUTION
CAUTION
MISE EN GARDE
CAUTION
Installation Preparation
Built-In Compactors
Option #3
Power
supply