GE Monogram ZIF36N RH Refrigerator User Manual


 
14
Step 2
Install
Water Line
Install optional water filter in the water line near the
refrigerator. A water filter is recommended in areas
where water supply contains sand or particles.
Installation instructions are packed with the filter.
A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 20 and 120 p.s.i.
Route 1/4" OD copper or GE SmartConnect
tubing between house cold water line and the water
connection location.
Tubing should be long enough to extend to the front of
the refrigerator. Allow enough to accommodate bend
leading into the water valve.
NOTE: The only GE approved plastic tubing is supplied
in the GE SmartConnect Refrigerator Tubing kits.
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
GE SmartConnect
Refrigerator Tubing Kits are
available in the following lengths:
2' (.6 m) WX08X10002
6' (1.8 m) WX08X10006
15' (4.6 m) WX08X10015
25' (7.6 m) WX08X10025
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the line
of water.
Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
Turn on the main water supply and flush debris from
the line. Run about a quart of water through the tubing
into a bucket. Shut off water at the shut-off valve.
NOTE: Saddle type shut-off valves are included in
many water supply kits. Before purchasing, make sure
a saddle type valve complies with local plumbing codes.
Floor
Tubing
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.
Installation
36" Refrigerators, Freezers