GE Monogram ZIF36N RH Refrigerator User Manual


 
27
Place the prepared 3/4" custom door panel on the
bottom trim with support bracket tabs inserted into
trim slots.
Push the panel back against the steel door, making
sure the panel is flush with the hinge side trim.
Secure the panel to the trim temporarily by driving
2 screws through the backside of the trim at the top.
Slide the handle extrusion in between the panel and
steel door.
Temporarily secure the extrusion to the door with
2 screws.
Step 1
Temporarily
mount door
panel
Step 3
Assemble
panel,
extrusion
and handle
Remove the handle extrusion, the 2 temporary screws
and custom panel.
Drill 1/16" pilot hole through extrusion.
Drill clearance holes through the panel and
extrusion.
Assemble the panel, extrusion and custom handle.
Install screw(s) long enough to pass through the
extrusion, door panel and into the handle.
Step 2
Locate
position
of handle
Determine the location of the custom handles
and carefully mark centerlines of the screw
holes. The handles must be located 3/4" to
1-1/2" from the edge of the extrusion.
Drill 1/16" pilot hole through the panel until
it starts into the aluminum extrusion. This
will mark the matching location for drilling
a clearance hole when assembling the
extrusion, panel and handle.
3/4" Min.
1-1/2" Max.
Screw
3/4" Min.
1-1/2" Max.
ZKHTR1 Trim Kit (For 3/4" Panels)
Support for Custom Handles