GE Monogram ZIF36N RH Refrigerator User Manual


 
26
3/4" custom door panel must be routed to accommodate
these door handle extrusions. Rout the panel as
illustrated, 1/4" deep, and 1-13/16" wide on the handle
side.
Refer to installation instructions for ZKTR36LH or
ZKTR36RH trim kit for 3/4" custom panels:
Follow Step 1 to remove the standard aluminum trim.
Follow Steps 2 and 3 to attach new 3/4" trim pieces
and to install panel support brackets.
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
Tools and materials required:
#2 Phillips screwdriver
Drill and appropriate bits
Custom door panel
Custom handle
Safety glasses
NOTE: This kit must be used in combination with ZKTR36LH
or ZKTR36RH trim kit for 3/4" panel trim.
Part List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
This kit provides the necessary framework to
install a custom handle, of your choice, onto a 3/4"
thick decorator door panel. (Handles not included.)
The handle extrusion allows the custom handle to be
secured to the door structure, rather than the door
panel.
Select handle extrusion for your model, discard other
extrusion.
Kit Contents
Before
you begin
IMPORTANT: Optimal final appearance depends on careful
routing depth. Do not exceed 1/4" routing depth.
1-13/16"
Back Side
Handle Side
Custom Panel
1/4" Max.
ZKHTR1 Trim Kit (For 3/4" Panels)
Support for Custom Handles