Filter
Top Products
User Maintenance Instructions
(Cont.)
Replacing the Oven Light Bulb:
Your George Foreman Rotisserie Oven uses a long-lasting bulb for
the oven light. However, if the light burns out, you can order
replacement bulbs. When using the Oven Light in your Rotisserie
Oven, we recommend using the light only as necessary to check
the status of the cooking food. Do not use the light continuously
during cooking as this will greatly reduce the life of the bulb.
You may order replacement bulbs by calling our Consumer
Department toll free at 1-800-233-9054, email us at
salton@saltonusa.com or write to:
Salton, Inc., 550 Business Center Drive, Mt. Prospect, Illinois 60056
WARNING: Do not attempt to disassemble or clean the unit while it
is plugged in and/or hot. Doing so could cause an electrical hazard.
1. Unplug Rotisserie Oven from outlet and allow to cool completely.
2. Locate light bulb compartment on inside of Rotisserie Oven
(along inside front panel).
3. Use a dime in slot of screw "A" to
twist and remove screw. (Screw "A"
is the only screw with a "slotted"
head as shown in Figure 13.)
Also, remove Glass Cover Bracket.
4. Carefully push Glass Cover all the
toward the right (away from
screws). Place your index finger into
Finger Indent and carefully lift Glass
Cover out. See Figure 14.
Carefully set Glass Cover aside.
4. Unscrew, remove, and discard
old light bulb.
5. Screw in new light bulb.
6. Replace Glass Cover. Be sure
Glass Cover fits between the
ledge and the two small tabs as
shown in Figure 14.
7. Align hole in Glass Cover Bracket
over hole in metal rim and secure
with Screw "A."
27
SCREW
"A"
GLASS
COVER
BRACKET
Figure 13
LEDGE
TABS
GLASS
COVER
FINGER
INDENT
LIGHT
BULB
Figure 14