Filter
Top Products
Flushing
309535L 17
9. Remove fluid filter and soak in solvent. Replace filter
cap.
10.Close sampling valves A and B.
14.Follow Pressure Relief Procedure, page 10, and
remove gun from hose. See gun manual to further
clean gun.
15.Clean hoppers as needed. Empty out solvent.
8. Repeat steps 5 and 7, using pump B setting
and sampling valve B, then press Stop .
11.Turn knob back to pump A . Press Start .
B
PSI
Bar
MPa
BA
B
A
0
B
A
I
O
PSI
Bar
MPa
PSI
Bar
MPa
BA
B
A
0
A
12.Trigger gun into grounded pail. Run pump until clean
solvent dispenses, then press Stop .
13.Repeat steps 11 and 12, using pump B setting,
then press Stop .
Some materials require additional cleaning. You
may need to recirculate solvent through the sys-
tem or disassemble the hopper, 3-way valve, and
strainer to clean them.
ti1953a
B
PSI
Bar
MPa
BA
B
A
0
B