Filter
Top Products
Spraying
22 309535L
Spraying
1. If heaters are used, turn them on. Operate heaters
as instructed in their manuals.
6. Follow Pressure Relief Procedure, page 10.
9. Follow Fluid Manifold Flushing, page 14, or Shut-
down, page 25, when you are done spraying or
before potlife expires.
WARNING
Wear gloves if fluid temperature exceeds 110° F (43°
C).
2. Close sampling valves A and B. Open shutoff valves
A and B.
3. Turn knob to spray . Press Start .
4. Trigger gun into a pail and slowly increase air regula-
tor pressure until pump is running and clean material
is dispensed.
AB
Open
Open
Close
Close
ti2249a
I
O
PSI
Bar
MPa
PSI
Bar
MPa
BA
B
A
0
I
O
PSI
Bar
MPa
PSI
Bar
MPa
ti1953a
5. Engage trigger lock. Press Stop .
7. Engage trigger lock. Install tip on gun.
8. Adjust air regulator to the necessary spraying pres-
sure and apply the coating. Refer to Mix and Inte-
gration Tests, page 23.
Mixed material potlife or working time
decreases with increased temperature.
I
O
PSI
Bar
MPa
PSI
Bar
MPa
BA
B
A
0
ti1949a
ti1949a