Filter
Top Products
4
English
1. Remove all packing materials. This includes the foam base and all adhesive
tape holding the accessories both inside and outside.
2. Inspect and remove any remaining packaging, tape or printed materials
before turning on the beer dispenser.
Note: Allow the beer dispenser to stand in an upright position for 2 hours before
turning on the power.
Check all supplied accessories in the carton to be sure that all pieces are present
and in good condition. A checklist of accessories is listed below for your
reference. If you find any accessories that are not in good condition or are
missing, please contact our customer service department for assistance.
Our Toll-Free number is 1-877-337-3639.
2 Keg Couplers (Beer Taps), Low Profile Type
1 CO2 Regulator, Single Gauge, Dual Outlet
1 CO2 Cylinder, 5 lbs.
1 Cleaning Kit, Including: 32 Ounce Bottle With Cap
4 Ounce Powder Cleaner
Faucet / Line Cleaning Brush
Spanner Wrench (For Installing Beer Faucets to
Draft Arm)
1 Draft Arm, 2 Faucet
Type Including: 2 Faucets
2 Red CO2 Lines
4 Hose Clamps
2 Black Knobs
1 3” Lower Gasket
1 CO2 Cylinder Ratainer (Bracket, nut and screw)
1 Guardrail
1 Drip Tray
4 Casters
1 Wrench
4 Large Phillips Head Screws
8 Small Phillips Head Screws
2 Retainer Fixing Screws
1 Keg Joining Bracket Kit
UNPACkINg ANd ACCESSORIES INVENTORY