Filter
Top Products
8
Power In
(male receptacle)
Exhaust Hood In
(female receptacle,
from
)
Power In
(male receptacle)
Exhaust Hood In
(female receptacle,
from )
Model 9200
Model 7200
Back of stove
Back of stove
1. When the range is fully assembled, recheck all electrical connections especially between
the exhaust hood and the back of the range. As well, check that all nuts and bolts have been
tightened.
2. Ensure teflon gliders and flooring are clean.
3. Caution: On flooring with very rough surfaces or deep, large grooves the appliance may
have to be lifted and slowly slid into position.
4. Put both hands on the trim and carefully push the range into place. Make sure floor is clear
of all debris. Don’t forget to plug in the main power cord and the exhaust hood power
cable before the range is in its final position. See closet installation instructions.
5. To level the range, simply adjust the levelling screws with teflon pads located at the bottom
of each leg. Using a 5/16” (8 mm) open-end wrench, turn the adjusting screw clockwise to
raise up the corner, and counter-clockwise to lower the corner. (Don’t forget the teflon glider
should extend beyond the bottom of the leg by approximately 1/8”-1/4”.)
6. Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the
flooring. When the range is in position and levelled, you may want to place coasters under the
teflon gliders of each leg to protect the floor. Remove the coasters when moving the range for
cleaning or servicing.
closet
closet
Positioning the Range