Filter
Top Products
The Wok burners are a little more complicated
but they can also be taken apart for cleaning.
When reassembling a Wok burner, turn over the
large base ring and find the ‘D’ shaped area.
Turn the head until the ‘D’ matches the one on
the burner base. Turn the head over and place it
on the burner base.
To fit the small inner burner, find the larger
electrode notch in the burner rim. Line this up
with the white ignition electrode and place the
inner burner on the large base ring.
A electrode notch B ignition electrode
Now fit the two trim rings, making sure that they
are sitting down properly.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water -
Wipe with a
clean dampened cloth then polish with a dry
cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean hot soapy
water.
The oven door is triple glazed but the oven door
front panel can be taken off so that the inside
faces of the glass panels can be cleaned.
If necessary move the range forward to gain
access to the sides of the doors (see the ‘Moving
the range’ section of these instructions).
The door front panel is held by four fixing screws,
two on each side: