Filter
Top Products
Installation Instructions
Improper installation, adjustment, alteration,
service or maintenance can cause injury or
property damage. Refer to this manual. For
assistance or additional information, consult a
qualified installer, service agency, manufacturer
(dealer) or the gas supplier. Never reuse old
flexible connectors. The use of old flexible
connectors can cause gas leaks and personal
injury. Always use NEW flexible connectors
when installing a gas appliance.
Remove all packing material and literature
from oven before connecting gas and electrical
supply to range.
• Have your range installed by a qualified
installer.
• Your range must be electrically grounded
in accordance with local codes or, in the
absence of local codes, in accordance with
the National Electrical Code (ANSI/NFPA 70,
latest edition).
• Before installing your range on linoleum or
any other synthetic floor covering, make sure
the floor covering can withstand 180°F without
shrinking, warping or discoloring. Do not
install the range over carpeting unless a sheet
of 1/4’’ thick plywood or similar insulator is
placed between the range and carpeting.
• Make sure the wall coverings around the
range can withstand heat generated by the
range up to 200°F.
• Avoid placing cabinets above the range. There
must be a gap of at least 30’’ (76cm) between
the top of the range and any combustible
surface above it.
If a ventilating hood is installed above the range
follow the installation instructions supplied with
the hood.
Items of interest to children should not be stored
above a range - children climbing on the range
to reach items could be seriously injured.
This appliance is supplied set for Natural gas.
A conversion kit for Propane gas is supplied with
the range.
If the appliance is to be converted this must be
done . The conversion must
be performed by a qualified LP gas installer.
See the Conversion section at the back of this
installation manual for more details.