Filter
Top Products
– 13 –
CLEANING
WARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE CLEANING.
Clean the machine immediately after each use. Dismantle all removable parts from the machine and
wash them in warm water and a mild detergent. Rinse thoroughly and wipe dry with a soft clean cloth.
Wipe the exterior of the machine with a damp cloth.
Allowing food juices to dry on the machine may cause discoloration. NEVER clean cutting tools or other
aluminum parts in highly alkaline dishwashing solutions or in excessively hot water as this can cause
formation of aluminum oxide (black). DO NOT use steel wool or sharp objects for cleaning machine
surfaces if they become discolored; scratched surfaces become hard to keep clean.
Do not leave the cutting blades in a wet condition when not in use.
Never clean the machine with a high pressure hose, with steam, or in a dishwasher.
Always store the cutting tools on the wall racks for safe handling and easy access.
To dismantle the machine for cleaning:
1. If the feed hopper attachment is installed, the nut (Fig. 14) securing the feed hopper agitator may
be removed (left-hand thread) with the wrench provided so that the agitator can be cleaned.
If the pusher plate attachment is installed, remove it by pressing the stop pad (see Fig. 10) down,
then swing the pusher plate attachment out clockwise, and pull it out of the feed cylinder tube.
Rinse all parts with lukewarm water.
Fig. 14
PL-52973
FEED HOPPER
AGITATOR
NUT