Filter
Top Products
– 5 –
VERIFY CORRECT ROTATION
Verify correct rotation of the knife shaft. Make sure it moves in a clockwise direction looking down into
the feed cylinder. If the rotation is incorrect, UNPLUG THE ELECTRICAL CORD and interchange any
two of the three power supply leads (non grounding wires) inside the plug. Then, verify that the rotation
is correct.
START-UP TESTING
1. Check that the machine stops when the locking handle (Fig. 1) is pulled forward, unlocking the feed
cylinder.
2. Check that the machine stops when the locking knob for the feed hopper attachment (Fig. 1) is
turned clockwise to the unlocked position, and that the machine restarts when the locking knob is
turned counterclockwise to the locked position.
3. Check that the machine stops when the pusher plate feed attachment (Fig. 2) is swung to the side
so that the feed cylinder (Fig. 2) opening is larger than 1
1
⁄4" (31.75 mm), and that the machine
restarts when the pusher plate feed attachment is swung back over the feed cylinder.
If the machine does not perform correctly, call your local Hobart Service Office before using the
machine.
Fig. 1 Fig. 2
PL-52964
LOCKING
HANDLE
LOCKING
KNOB
FEED
CYLINDER
OPENING
PUSHER
PLATE
PL-52965