Filter
Top Products
– 13 –
PROGRAMMING THE OVEN
Single Step Programming
The program menu stores up to 99 programs that can be recalled by number when needed. A program
is a set of baking instructions (temperature, bake, steam and airflow delay settings) that the operator
defines for any baking operation.
1. With the oven in the OFF mode, press and hold the UP arrow in the STEPS section. While
pressing and holding the UP arrow, press the POWER ON OFF button for 3 seconds. When the
beep sounds, the oven is in program mode.
2. Press the PROGRAM UP or DOWN arrows until the program number that is desired is displayed.
3. Press the TEMP UP or DOWN arrows to enter the desired temperature.
4. Set the Bake, Steam, Delay Airflow and Vent settings:
• Press the UP or DOWN arrows next to BAKE TIMER to enter the desired time.
• Press the UP or DOWN arrows next to STEAM TIMER to enter the desired time.
• Press the UP arrow next to AIRFLOW DELAY to enter the desired time.
NOTE: Steam and airflow delay settings are optional and can be left at 0 if desired.
• Press the VENT button to vent the cavity for the entire time of the step. When step is
complete, vent will close.
5. To store the program, press the PROGRAM UP or DOWN arrows to move to the next program
number or press the POWER ON OFF button to exit the program mode. To store additional
program settings, repeat steps 2 to 4.
6. Record program numbers, and product associated with them, on the bake card supplied with the
oven.