Filter
Top Products
– 8 –
Control Guide - Advanced (cont)
Button Action Display
Press to stop the BAKE The ON light is off when the BAKE TIMER is inactive.
TIMER or silence the
beeper after the BAKE
TIMER has timed out.
PROGRAM
Press to select bake The PROGRAM window displays the number of the
program. current program.
STEP
Press to select one of The corresponding indicator light will be lit (1 to 4),
four baking steps. depending on which step is selected.
Press to open or The indicator light above the VENT button is lit when the
close the vent. vent cycle is enabled.
Auto On/Off Timer and Clock
The Auto ON/OFF Timer display shows the current time of day. To set the clock, the control must be
turned on. Press and hold either arrow button to initiate clock setting, then adjust time using arrow
buttons. A few seconds after the time is adjusted, the colon in the time display will resume flashing.
Timer Settings
The oven can be set to turn itself on and off. After the AUTO ON/OFF TIMER is set, the POWER ON
OFF button can be pressed to turn the oven off. This will not disrupt the AUTO ON/OFF setting.
Electrical power to the oven must remain on.
1. To set the oven to turn on, press and
hold
the AUTO ON TIME button. The previously entered
start time will appear in the display. Use the UP and DOWN arrows to adjust the start time. Then
release the AUTO ON TIME button.
2. To set the oven to turn off, press and
hold
the AUTO OFF TIME button. The previously entered
end time will appear in the display. Use the UP and DOWN arrows to adjust the end time. Then
release the AUTO ON TIME button.
3. To enable the automatic start, press and
hold
the TIMER ON/OFF button until the indicator LED
to the right of the TIMER ON/OFF button is illuminated.
NOTE: When using AUTO ON/OFF to preheat the oven, if the oven is not disturbed for the time set
in parameter P17, it will revert to the Setback temperature stored in parameter P18 setup.
Backup Battery
The clock is backed up by a lithium battery which keeps the clock circuitry operating when all external
power is off. If the battery becomes low or dead while the external power is off, the display will read
12:00 (12 hr mode) or 0:00 (24 hr mode) and will not increment until a new time is set. The clock will
operate with a dead or missing battery, but must be set each time external power is turned on. Batteries
should be replaced when low or dead to avoid corrosive damage to the circuitry. Contact your local
Hobart Bakery Systems service office.